3D Printer - Tevo Tornado

From Tech Valley Center of Gravity Wiki
Jump to navigation Jump to search
Tevo Tornado
Printer Style: FDM
Bed Size: 300 x 300 mm
Max Print Height: 400 mmmm
Resolution: 0.1 mm layer, 0.4mm nozzle
Filament Diameter: 1.75mm
Max Temp: 230°C
Firmware: unknown
Manufacturer: Tevo
Link: https://tevo3dprinterstore.com/products/tevo-tornado-most-assembled-full-aluminum-frame-3d-printer-eu-plug-220v-shipping-from-germany-warehouse?variant=8117770944603


Description

A Fused Deposition Modeling (aka Fused Filament Fabrication) 3D printer.

Safety Rules

Documentation

NOTE: These materials are not a substitute for hands-on training with an experienced user.

Notes

  • Use presets in Simplify3D as a starting point. If you adjust parameters, DO NOT save over the default file.
  • Clean bed with isopropyl alcohol wipes before use.
  • Take care not to damage the heater bed when removing parts. Use plastic spatulas only.

Operation Instructions

Changing the Filament

Removing Filament
  1. Preheat the nozzle using the Preheat selection on the menu.
  2. Hold down the filament tension lever.
  3. Slightly push in filament (about 0.1"), then pull filament out.
  4. Store filament in a plastic bag with desiccant.
Inserting Filament
  1. Preheat the nozzle using the Preheat selection on the menu.
  2. Trim filament end to a point.
  3. Hold down filament tension lever.
  4. Insert filament into tube.
  5. Continue to press filament in until it is extruding out the nozzle.
  6. Release filament tension lever.

References